angle of slide
英 [ˈæŋɡl ɒv slaɪd]
美 [ˈæŋɡl əv slaɪd]
滑动角
双语例句
- When the dipping angle of the slide surface is steep, the whole sliding will be predominant, which implies that load design could be determined by classical slice methods.
当滑动面倾角较大时，滑动效应占主导地位，抗滑桩的设计荷载可根据各种条分法来确定。 - When the dip of bedding is less than the friction angle of rock, the rock stratum will separate and some rock blocks in every rock stratum may slide along joint surface as a whole.
试验结果表明：①当层理倾角小于岩块摩擦角时，岩层发生离层，各层内的部分岩块整体性沿节理面滑落； - The angle of internal friction of slide plane has greater effects on anchor force, therefore, that should be selected correctly.
滑动面内摩擦角对锚固力影响较大，须正确选用。 - Use of the Maximum of the Minimum Transmission Angle in the Optimum Design of Crank and Slide Block Mechanisms
最小传动角在曲柄滑块机构优化设计中的应用 - This article will introduce the suppling structure's pattern, dip angle, the design of the material storehouse's slide, calculation, existing problems and it's improving measures of the trough material storehouse.
本文主要介绍了常用槽形料仓式供料机构的结构型式、料仓滑道的设计计算及存在的问题和改进措施。 - C and ( cohesive force and interior friction angle of slide surfaces);
C和φ（滑动面的内聚力和内摩擦角）； - ',' and m ( slide rock soil unit weight, interior friction angle and proportion coefficient of coefficient of slide bed);
γ′、φ′，和m（滑床的岩土容重、内摩擦角和地基系数的比例系数）； - The experiment results show that the diameter of seedling, speed of rotation and angle of slide cutting respectively influence the cutting resistance in sequence.
结果表明，苗木直径、转速、滑切角依次影响切削阻力大小，苗木直径与切削阻力呈平方关系； - Based on the magnitude of natural repose angle of soil and slope angle, earth slide is divided into shallow slide and deep slide, and respectively discussed. Combined with engineering, the slide safety factor is calculated and accorded very well with practice. 4.
根据土体的自然休止角及坡角的大小分为浅层滑坡和深层滑坡两种情况进行讨论，结合实际工程计算出边坡安全系数，与实际情况吻合较好。 - The Runge-Kutta method is utilized to obtain the relationship between the angle as well as the angular velocity and time in the case of the slide way structure.
基于Runge-Kutta方法得到了在滑道式俯仰角控制结构下分离过程中模型角度、角速度与时间之间的对应关系。